Color: As Picture
Plug Type: US
Size: 520 x 393 x 487mm/20.5 x 15.5 x 19.2inch Print Size: 260 x 260 x 270mm
Nozzle Diameter: 0.4mm
Machine input power: AC220-1.3A/AC110-2.6A
Machine output power: DC24V-10A
Insulation withstand voltage: 500Vac/10mA/1min
Insulation resistance: DC500V (10MΩMIN)
Online applicable software: Cura, etc.
Environmental humidity: ≦80%
Ambient temperature: -30-38℃
Voltage fluctuation: AC220V±10% AC110V±10%
Complex construction injection molding.
High printing precision, good result and easy reloading filament. Printing speed: 70mm/s is regularly used. If it is too fast, the surface of the model may be rough or deformed as a result of heat dissipation and vibration, such as 200mm/s.
High-precision: Get creative with high-precision 3D printers. Power supply safety protection: undervoltage protection, short circuit protection, overcurrent protection, leakage protection.
Environmental requirements: Air requirements: harmful, flammable, and explosive gases don’t seem to be allowed in the use environment, and the maximum PM10 is 0.15ug/M³ (exceeding may have an effect on the service life of the fan)
Package Content: 1 x 3D Printer
Make sure this fits by entering your model number.
HIGH PRECISION: We exclusively research and develop the extruder feeding system to enhance high-speed printing, and accuracy can reach up to 0.1 mm, it allows to extrude filament steady without block.Precision up to: 0.1 mm, Speed up to: 200 mm/s
STABILITY:The whole-steel body not only ensure the stability all through printing but also greatly extend working life. The optimization and cooperation of overall structure ensure the sustainable and efficient operation.
OUTAGR RESTORED & FILAMENT DETECTION:The printer will automatically memorize the current position and save print data. Lower the platform and withdraw filament when power off suddenly. It’s going to continue to print from the last stopped point after power’s on.The printer will avoid invalid printing by stoping print and warning when filament runs out.
3D PRINTER GLASS BED:A 3D printer glass bed is arguably the most suitable choice when aiming for a flawless print bottom. Not only that, it’s also remarkably easy to remove prints from glass (providing your bed was clean before the print). In reality, within the 3D printing community, the joke goes that just knocking on the printer is enough to make it slide.
DOUBLE Z AXIS: Unlike the Z-axis single screw in the marketplace, M09 uses a Z-axis double screw, dual motor + double screw + double Z axis limit switch to ensure the stability and flatness of the printing platform.